Enterasys C3G124-24 - Set Rmon Stats; Show Rmon Stats

show rmon stats
21-4 RMON Configuration
show rmon stats
Use this command to display RMON statistics measured for one or more ports.
Syntax
show rmon stats [port-string]
Parameters
Defaults
If port-string is not specified, RMON stats will be displayed for all ports.
Mode
Switch command, read-only.
Example
This example shows how to display RMON statistics for Gigabit Ethernet port 1 in switch 1.
:
C3(su)->show rmon stats ge.1.1
Port: ge.1.1
-------------------------------------
Index = 1
Owner = monitor
Data Source = ifIndex.1
Drop Events = 0 Packets = 0
Collisions = 0 Octets = 0
Jabbers = 0 0 - 64 Octets = 0
Broadcast Pkts = 0 65 - 127 Octets = 0
Multicast Pkts = 0 128 - 255 Octets = 0
CRC Errors = 0 256 - 511 Octets = 0
Undersize Pkts = 0 512 - 1023 Octets = 0
Oversize Pkts = 0 1024 - 1518 Octets = 0
Fragments = 0
set rmon stats
Use this command to configure an RMON statistics entry.
Syntax
set rmon stats index port-string [owner]
Parameters
port-string (Optional) Displays RMON statistics for specific port(s).
index Specifies an index for this statistics entry.
port-string Specifies port(s) to which this entry will be assigned.
owner (Optional) Assigns an owner for this entry.