Enterasys C3G124-24 - Clear Snmp Interface; Commands; Purpose; Configuring the SNMP Engine ID

clear snmp interface
Enterasys C3 Configuration Guide 12-39
C3(rw)->set snmp interface vlan 100
C3(rw)->show snmp interface
vlan 100 192.168.10.1
clear snmp interface
Use this command to clear the interface used for the source IP address of the SNMP agent back to
the default of the Host interface.
Syntax
clear snmp interface
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This command returns the interface used for the source IP address of the SNMP agent back to the
default of the Host interface.
C3(rw)->show snmp interface
vlan 100 192.168.10.1
C3(rw)->clear snmp interface
C3(rw)->
Configuring the SNMP Engine ID
Purpose
To display the SNMP local engine ID and to configure a non-default SNMP engine ID on the
switch.
Commands
For information about... Refer to page...
show snmp engineid 12-40
set snmp engineid 12-40
clear snmp engineid 12-41