Enterasys C3 Configuration Guide 26-1
26
IPv4 Basic Routing Protocol Configuration
This chapter describes how to use the commands for the IPv4 basic routing protocols. These
routing protocols do not require an advanced routing license.
Configuring RIP
RIP Configuration Task List and Commands
Table 26-1 lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 24-2.
For information about... Refer to page...
Configuring RIP 26-1
Configuring IRDP 26-11
Note: The command prompts used in examples throughout this chapter show a system where the
VLAN 1 interface has been configured for routing. The prompt changes depending on your current
configuration mode, your specific device, and the interface types and numbers configured for
routing on your system.
Table 26-1 RIP Configuration Task List and Commands
To do this... Use these commands...
Enable RIP configuration mode. “router rip” on page 26-2
Enable RIP on an interface. “ip rip enable” on page 26-7
Configure an administrative distance. “distance” on page 26-3
Allow reception of a RIP version. “ip rip send version” on page 26-8
Allow transmission of a RIP version. “ip rip receive version” on page 26-8
Configure RIP simple authentication. “ip rip authentication-key” on page 26-9
Configure RIP encrypted authentication. “ip rip message-digest-key” on page 26-10
Disable automatic route summarization
(necessary for enabling CIDR)
“no auto-summary” on page 26-4
To Next Page
Loading...
