clear macauthentication portquietperiod
Enterasys C3 Configuration Guide 32-35
Defaults
None.
Mode
Switch command, read-write.
Example
This example sets port 1 to wait 5 seconds after a failed authentication attempt before a new
attempt can be made:
C3(su)->set macauthentication portquietperiod 5 ge.1.1
clear macauthentication portquietperiod
This sets the quiet period back to the default value of 30 seconds.
Syntax
clear macauthentication portquietperiod [port-string]
Parameters
Defaults
If a port-string is not specified then all ports will be set to the default port quiet period.
Mode
Switch command, read-write.
Example
This example resets the default quiet period on port 1:
C3(su)->clear macauthentication portquietperiod ge.1.1
set macauthentication macinitialize
Use this command to force a current MAC authentication session to re-initialize and remove the
session.
Syntax
set macauthentication macinitialize mac-addr
Parameters
port-string (Optional) Specifies the ports for which the quiet period is to be reset. For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.
mac-addr Specifies the MAC address of the session to re-initialize.
To Next Page
Loading...
