Enterasys C3G124-24 - Show Lacp Output Details

show lacp
11-48 Port Configuration
Defaults
If port-string is not specified, link aggregation information for all LAGs will be displayed.
Mode
Switch command, read-only.
Usage
Each Enterasys C3 switch provides 6, 12, or 24 virtual link aggregator ports, which are designated
in the CLI as lag.0.1 through lag.0.24, depending on how many LAG groups have been
configured. See “set lacp groups” on page 11-58.
Once underlying physical ports (that is, ge.x.x) are associated with an aggregator port, the
resulting aggregation will be represented as one Link Aggregation Group (LAG) with a lag.0.x
port designation.
Example
This example shows how to display lacp information for lag.0.1. The following table describes the
output fields.
C3(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs: disabled
Aggregator: lag.0.1
Actor Partner
System Identifier: 00:01:F4:5F:1E:20 00:11:88:11:74:F9
System Priority: 32768 32768
Admin Key: 65535
Oper Key: 65535 101
Attached Ports: ge.1.1
ge.1.3
Table 11-7 provides an explanation of the command output.
Table 11-7 show lacp Output Details
Output Field What It Displays...
Global Link
Aggregation state
Shows if LACP is globally enabled or disabled on the switch.
Single Port LAGs Displays if the single port LAG feature has been enabled on the switch. See “set lacp
singleportlag” on page 11-52 for more about single port LAG.
Aggregator LAG port designation. Each Enterasys C3 module provides 6, 12, or 24 virtual link
aggregator ports, which are designated in the CLI as lag.0.1 through lag.0.24. Once
underlying physical ports (for example,
fe.x.x) are associated with an aggregator
port, the resulting Link Aggregation Group (LAG) is represented with a lag.0.x port
designation.
Actor Local device participating in LACP negotiation.
Partner Remote device participating in LACP negotiation.
System Identifier MAC addresses for actor and partner.
System Priority System priority value which determines aggregation precedence. Only one LACP
system priority can be set on a Enterasys C3 device, using either the set lacp
asyspri command (page 11-49), or the set port lacp command (page 11-55)
.
Admin Key Port’s assigned key. Enterasys C3 devices provide a default admin key value of
32768 for all LAG ports (lag.0.x).