Enterasys C3G124-24 - Set Snmp Notifyprofile

set snmp notifyprofile
12-34 SNMP Configuration
Parameters
Defaults
If no parameters are specified, all notify profile information will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display SNMP notify information for the profile named “area51”:
C3(su)->show snmp notifyprofile area51
--- SNMP notifyProfile information ---
Notify Profile = area51
TargetParam = v3ExampleParams
Storage type = nonVolatile
Row status = active
set snmp notifyprofile
Use this command to create an SNMP notify filter profile configuration. This associates a
notification filter, created with the set snmp notifyfilter command (“set snmp notifyfilter” on
page 12-32), to a set of SNMP target parameters to determine which management targets should
not receive SNMP notifications.
Syntax
set snmp notifyprofile profile targetparam targetparam [volatile | nonvolatile]
Parameters
Defaults
If storage type is not specified, nonvolatile (permanent) will be applied.
Mode
Switch mode, read-write, when security profile = normal.
profile (Optional) Displays a specific notify profile.
targetparam
targetparam
(Optional) Displays entries for a specific target parameter.
volatile |
nonvolatile | read-
only
(Optional) Displays notify filter entries of a specific storage type.
profile Specifies an SNMP filter notify name.
targetparam
targetparam
Specifies an associated entry in the SNMP Target Params Table.
volatile |
nonvolatile
(Optional) Specifies a storage type.