Enterasys C3 Configuration Guide 36-1
36
TACACS+ Configuration
This chapter provides information about the commands used to configure and monitor TACACS+
(Terminal Access Controller Access-Control System Plus).
TACACS+ is a security protcol that provides services for secure authentication, CLI command
authorization, and CLI auditing for administrative access. It can be used as an alternative to the
standard RADIUS security protocol (RFC 2865). TACACS+ runs over TCP and encrypts the body
of each management packet.
Based on the now obsolete TACACS protocol (defined in RFC 1492), TACACS+ is defined in an
un-published and expired Internet Draft draft-grant-tacacs-02.txt, “The TACACS+ Protocol
Version 1.78,” January, 1997.
For detailed information about using TACACS+ in your network, refer to the Enterasys Feature
Guide “TACACS+ Configuration” located on the Enterasys web site:
https://extranet.enterasys.com/downloads/
For information about... Refer to page...
show tacacs 36-2
set tacacs 36-3
show tacacs server 36-3
set tacacs server 36-4
clear tacacs server 36-5
show tacacs session 36-6
set tacacs session 36-7
clear tacacs session 36-8
show tacacs command 36-9
set tacacs command 36-9
show tacacs singleconnect 36-10
set tacacs singleconnect 36-10
show tacacs interface 36-11
set tacacs interface 36-11
clear tacacs interface 36-12
To Next Page
Loading...
Need help?
General