Enterasys C3G124-24 - Configuring IRDP; Purpose; Commands; Ip Irdp Enable

Configuring IRDP
Enterasys C3 Configuration Guide 26-11
Configuring IRDP
Purpose
To enable and configure the ICMP Router Discovery Protocol (IRDP) on an interface. This protocol
enables a host to determine the address of a router it can use as a default gateway. It is disabled by
default.
Commands
ip irdp enable
Use this command to enable IRDP on an interface. The no form of this command disables IRDP on
an interface.
Syntax
ip irdp enable
no ip irdp enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C3(su)->router(Config-if(Vlan 1))#
Example
This example shows how to enable IRDP on the VLAN 1 interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip irdp enable
For information about... Refer to page...
ip irdp enable 26-11
ip irdp maxadvertinterval 26-12
ip irdp minadvertinterval 26-12
ip irdp holdtime 26-13
ip irdp preference 26-13
ip irdp broadcast 26-14
show ip irdp 26-14