Enterasys C3G124-24 - Show Dhcpsnooping Port

show dhcpsnooping port
23-10 DHCP Snooping and Dynamic ARP Inspection
Defaults
None.
Mode
Switch command, read-write.
Usage
This command displays the status (enabled or disabled) of DHCP snooping globally, lists the
VLANs on which DHCP snooping is enabled, displays whether source MAC address verification
is enabled or disabled, and for ports that are enabled for snooping, displays whether they are
trusted or untrusted and whether logging of invalid packets has been enabled.
Example
This example shows the output of the show dhcpsnooping command.
C3(su)->show dhcpsnooping
DHCP snooping is Enabled
DHCP snooping source MAC verification is enabled
DHCP snooping is enabled on the following VLANs:
3
Interface Trusted Log Invalid Pkts
----------- ---------- ----------------
ge.1.47 Yes No
ge.1.48 No No
lag.0.1 No No
show dhcpsnooping port
Use this command to display DHCP snooping configuration parameters for specific ports.
Syntax
show dhcpsnooping port port-string
Parameters
Defaults
None.
Mode
Switch command, read-write.
Usage
This command displays the trust state and rate limiting parameters configured on the specified
ports.
port-string Specifies the port or ports for which to display configuration
information.