Overview
29-2 IPv6 Configuration
autoconfiguration is part of Router Advertisement and the Enterasys C3 can support both stateless
and stateful autoconfiguration of end nodes. The Enterasys C3 supports both EUI-64 interface
identifiers and manually configured interface IDs.
Refer to the following RFCs for more information about Neighbor Discovery and stateless address
autoconfiguration:
• RFC 4861, “Neighbor Discovery for IP Version 6”
• RFC 4862, “IPv6 Stateless Address Autoconfiguration”
For ICMPv6, error PDU generation is supported, as are path MTU, echo, and redirect.
Router Advertisement is an integral part of IPv6 and is supported. Numerous options are
available including stateless/stateful address configuration, router and address lifetimes, and
Neighbor Discovery timer control. Ping and traceroute applications for IPv6 are provided.
Management of IPv6 features is provided by means of CLI commands and SNMP. See Chapter 28,
IPv6 Management for descriptions of the CLI commands.
Default Conditions
The following table lists the default IPv6 conditions.
Condition Default Value
IPv6 forwarding Enabled
IPv6 route distance 1
IPv6 maximum hop limit 64
IPv6 unicast-routing Disabled
IPv6 enable Disabled
IPv6 mtu 1500
IPv6 nd dad attempts 1
IPv6 nd managed-config-flag False
IPv6 nd ns-interval 0
IPv6 nd other-config-flag False
IPv6 nd ra-interval 600
IPv6 nd ra-lifetime 1800
IPv6 nd reachable-time 0
IPv6 nd suppress-ra Disabled
IPv6 nd prefix Valid-lifetime — 604800
Preferred-lifetime — 2592000
Autoconfig — enabled
On-link — enabled
To Next Page
Loading...
Need help?
General