ip ospf retransmit-interval
27-8 IPv4 Advanced Routing Protocol Configuration
Parameters
Defaults
None.
Mode
Router configuration: C3(su)->router(Config-router)#
Example
This example shows how to set SPF delay time to 7 seconds and hold time to 3:
C3(su)->router(Config)#router ospf 1
C3(su)->router(Config-router)#timers spf 7 3
ip ospf retransmit-interval
Use this command to set the amount of time between retransmissions of link state advertisements
(LSAs) for adjacencies that belong to an interface. The no form of this command resets the
retransmit interval value to the default, 5 seconds.
Syntax
ip ospf retransmit-interval seconds
no ip ospf retransmit-interval
Parameters
Defaults
None.
Mode
Interface configuration: C3(su)->router(Config-if(Vlan 1))#
Example
This example shows how to set the OSPF retransmit interval for the VLAN 1 interface to 20:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip ospf retransmit-interval 20
spf-delay Specifies the delay, in seconds, between the receipt of an update and the SPF
execution. Valid values are 0 to 4294967295.
spf-hold Specifies the minimum amount of time, in seconds, between two
consecutive OSPF calculations. Valid values are 0 to 4294967295. A value of
0 means that two consecutive OSPF calculations are performed one
immediately after the other.
seconds Specifies the retransmit time in seconds. Valid values are 1 to 65535.
To Next Page
Loading...
Need help?
General