Enterasys C3 Configuration Guide 10-1
10
Discovery Protocol Configuration
This chapter describes how to configure discovery protocols. For more extensive configuration
information, refer to the “Configuring Neighbor Discovery” feature guide on the Enterasys
Networks web site: https://extranet.enterasys.com/downloads/
Configuring CDP
Purpose
To review and configure the Enterasys CDP discovery protocol. This protocol is used to discover
network topology. When enabled, this protocol allows Enterasys devices to send periodic PDUs
about themselves to neighboring devices.
Commands
The commands used to review and configure the CDP discovery protocol are listed below.
For information about... Refer to page...
Configuring CDP 10-1
Configuring Cisco Discovery Protocol 10-7
Configuring Link Layer Discovery Protocol and LLDP-MED 10-13
For information about... Refer to page...
show cdp 10-2
set cdp state 10-3
set cdp auth 10-4
set cdp interval 10-4
set cdp hold-time 10-5
clear cdp 10-5
show neighbors 10-6
To Next Page
Loading...
Need help?
General