set snmp persistmode
3-36 Basic Configuration
Defaults
None.
Mode
Switch command, read-only.
Usage
By default, the mode is set to “auto save,” which automatically saves configuration changes at
specific intervals. If the mode is set to “manual,” configuration commands are never automatically
saved. In order to make configuration changes persistent when the mode is manual, the save
config command must be issued as described in “Configuration Persistence Mode” on page 3-34.
Example
This example shows how to display the configuration persistence mode setting. In this case,
persistence mode is set to “manual”, which means configuration changes are not being
automatically saved.
C3(su)->show snmp persistmode
persistmode is manual
set snmp persistmode
Use this command to set the configuration persistence mode, which determines whether user-
defined configuration changes are saved automatically, or require issuing the save config
command. See “Configuration Persistence Mode” on page 3-34 for more information.
Syntax
set snmp persistmode {auto | manual}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the configuration persistence mode to manual:
C3(su)->set snmp persistmode manual
auto Sets the configuration persistence mode to automatic. This is the default
state.
manual Sets the configuration persistence mode to manual. In order to make
configuration changes persistent, the save config command must be
issued as described in “save config” on page 3-37. This mode is useful for
reverting back to old configurations.
To Next Page
Loading...
