clear spantree bridgeprioritymode
13-12 Spanning Tree Configuration
Mode
Switch command, read-write.
Usage
The mode affects the range of priority values used to determine which device is selected as the
Spanning Tree root as described in set spantree priority (“set spantree priority” on page 13-18).
The default for the switch is to use 802.1t bridge priority mode.
Example
This example shows how to set the bridge priority mode to 802.1D:
C3(rw)->set spantree bridgeprioritymode 8021d
clear spantree bridgeprioritymode
Use this command to reset the Spanning Tree bridge priority mode to the default setting of 802.1t.
Syntax
clear spantree bridgeprioritymode
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to reset the bridge priority mode to 802.1t:
C3(rw)->clear spantree bridgeprioritymode
show spantree mstilist
Use this command to display a list of Multiple Spanning Tree (MST) instances configured on the
device.
Syntax
show spantree mstilist
Parameters
None.
Defaults
None.
To Next Page
Loading...
Need help?
General