Enterasys C3G124-24 - Dhcpv6 Show Commands; Purpose; Commands; Show Ipv6 Dhcp

DHCPv6 Show Commands
Enterasys C3 Configuration Guide 30-13
DHCPv6 Show Commands
Purpose
These commands are used to display DHCPv6 configuration information and statistics, to clear
statistics globally or for a specific interface, and to display address pool and binding information.
Commands
show ipv6 dhcp
This command displays the state of DHCPv6 on the switch and the switch’s DHCP unique
identifier (DUID).
Syntax
show ipv6 dhcp
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Example
This example illustrates the output of this command when DHCPv6 is enabled on the switch.
C3(su)->router# show ipv6 dhcp
DHCPv6 is enabled
Server DUID: 00:01:00:06:90:83:57:c7:00:11:88:56:5d:58
For information about... Refer to page...
show ipv6 dhcp 30-13
show ipv6 dhcp interface 30-14
show ipv6 dhcp statistics 30-16
clear ipv6 dhcp statistics 30-17
show ipv6 dhcp pool 30-18
show ipv6 dhcp binding 30-18