Configuring Access Control Lists access-list interface
34-14
access-list interface
Use this command to apply access control lists to ports.
Syntax
access-list interface {acl-name | acl-number} port-string [in | out] [sequence
sequence]
no access-list interface {acl-name | acl-number} port-string [in | out]
Parameters
Defaults
If direction is not specified, the direction will be inbound.
If the sequence is not specified, the access control list will be applied in the order in which it was
associated with the interface.
Mode
Global configuration: C3(su)->router(Config)#
Example
This example applies an access control list to a port list.
C3(su)->router(Config)#access-list interface 101 ge.1.1-24
acl-number | acl-
name
Specifies the name or number of the access list to be applied to the port.
MAC-based and IPv6 access control lists are identified by name. Standard
and extended access control lists are identifed by a decimal number from 1
to 199.
port-string Specifies the port or ports to which the access control list will be applied.
in | out (Optional) Specifies the direction of the packets (inbound or outbound) to
which the access control list will be applied.
sequence sequence (Optional) Specifies the order in which this access control list is applied
relative to other ACLs that may already be associated with the port.
To Next Page
Loading...
