Enterasys C3G124-24 - Area Configuration Commands; Purpose; Commands

Area Configuration Commands
31-10 OSPFv3 Configuration
Mode
Router configuration: C3(su)->router(Config-router)#
Usage
Passive mode allows an interface to be included in the OSPF route table, but turns off sending and
receiving hellos for the interface. It also prevents OSPF adjacencies from being formed on an
interface.
The no form of this command disables passive OSPF mode.
Examples
This example enables passive OSPF mode on VLAN 102.
C3(su)->router(Config)#ipv6 router ospf
C3(su)->router(Config-router)#passive-interface vlan 102
This example shows how to make passive OSPF mode the default mode on all interfaces.
C3(su)->router(config#ipv6 router ospf
C3(su)->router(Config-router)#passive-interface default
Area Configuration Commands
Purpose
These commands are used to configure area parameters.
Commands
For information about... Refer to page...
area default-cost 31-11
area nssa 31-11
area nssa default-info-originate 31-12
area nssa no-redistribute 31-13
area nssa no-summary 31-13
area nssa translator role 31-14
area nssa translator-stab-intv 31-15
area range 31-15
area stub 31-16
area stub no-summary 31-17
area virtual-link 31-18
area virtual-link dead-interval 31-18
area virtual-link hello-interval 31-19
area virtual-link retransmit-interval 31-20
area virtual-link transmit-delay 31-20