Enterasys C3G124-24 - Clear Ipv6 Gateway

clear ipv6 gateway
28-6 IPv6 Management
Usage
This command configures the IPv6 gateway address. Only one IPv6 gateway address can be
configured for the switch, so executing this command when a gateway address has already been
configured will overwrite the previously configured address.
Use the show ipv6 address command to display a configured IPv6 gateway address.
Example
This example shows how to configure an IPv6 gateway address using a link-local address.
C3(su)->set ipv6 gateway fe80::201:f4ff:fe5d:1234
C3(su)->show ipv6 address
Name IPv6 Address
------------ ----------------------------------------
host FE80::201:F4FF:FE5C:2880/64
gateway FE80::201:F4FF:FE5D:1234
clear ipv6 gateway
Use this command to clear an IPv6 gateway address.
Syntax
clear ipv6 gateway
Parameters
None.
Defaults
None.
Mode
Switch mode, read-write.
Example
This example shows how to remove a configured IPv6 gateway address.
C3(su)->show ipv6 address
Name IPv6 Address
------------ ----------------------------------------
host FE80::201:F4FF:FE5C:2880/64
gateway FE80::201:F4FF:FE5D:1234
C3(su)->clear ipv6 gateway
C3(su)->show ipv6 address
Name IPv6 Address
------------ ----------------------------------------
host FE80::201:F4FF:FE5C:2880/64