Enterasys C3G124-24 - Show Ipv6 Ospf Interface

show ipv6 ospf interface
Enterasys C3 Configuration Guide 31-39
show ipv6 ospf interface
This command displays information about OSPFv3 interfaces.
Syntax
show ipv6 ospf interface {vlan vlanid | tunnel tunnelid | loopback loopid}
Parameters
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Examples
This example displays information about OSPFv3 routing interface VLAN 80.
C3(su)->router>show ipv6 ospf interface vlan 80
IPv6 Address FE80::211:88FF:FE56:5D8F
ifIndex 430
OSPF Admin Mode Enable
OSPF Area ID 0.0.0.20
Router Priority 1
Retransmit Interval 5
Hello Interval 10
Dead Interval 40
LSA Ack Interval 1
Iftransit Delay Interval 1
Link Unknown Total number of link-source unknown LSAs in the OSPFv3 link
state database.
Area Unknown Total number of area unknown LSAs in the OSPFv3 link state
database.
AS Unknown Total number of as unknown LSAs in the OSPFv3 link state
database.
Self Originated Type-7 Total number of self-originated NSSA External Link-State
Advertisements in the OSPFv3 link state database.
Type-5 Ext Total number of AS external LSAs in the OSPFv3 link state
database.
Self-Originated Type-5 Total number of self originated AS external LSAs in the OSPFv3
link state database.
Total Total number of router LSAs in the OSPFv3 link state database.
Table 31-6 show ipv6 ospf database database-summary Output Details (Continued)
Output Field What It Displays...
vlan vlanid Specifies the VLAN interface to display information about.
tunnel tunnelid Specifies the tunnel interface to display information about.
loopback loopid Specifies the loopback interface to display information about.