ip pimsm
27-38 IPv4 Advanced Routing Protocol Configuration
ip pimsm
This command sets administrative mode of PIM-SM multicast routing across the router to
enabled. IGMP must be enabled before PIM-SM can be enabled. By default, both IGMP and PIM
are globally disabled. The no form of this command disables PIM-SM (across the entire stack, if
applicable).
Syntax
ip pimsm
no ip pimsm
Parameters
None.
Defaults
None.
Mode
Global router configuration: C3(su)->router(Config)#
Example
This example shows how to globally enable and disable PIM:
C3(su)->router(Config)# ip pimsm
C3(su)->router(Config)# no ip pimsm
ip pimsm staticrp
This command is used to create a manual Rendezvous Point IP address for the PIM-SM router.
The no form of this command removes a previously configured RP.
Syntax
ip pimsm staticrp ipaddress groupadress groupmask
no ip pimsm staticrp ipaddress groupadress groupmask
Display commands
show ip pimsm 27-40
show ip pimsm componenttable 27-41
show ip pimsm interface 27-42
show ip pimsm neighbor 27-43
show ip pimsm rp 27-44
show ip pimsm rphash 27-45
show ip pimsm staticrp 27-46
show ip mroute 27-47
For information about... Refer to page...
To Next Page
Loading...
Need help?
General