Enterasys C3G124-24 - Set Linkflap Interval; Set Linkflap Action

set linkflap interval
11-28 Port Configuration
Parameters
Defaults
If port-string is not specified, all ports are enabled or disabled.
Mode
Switch command, read-write.
Example
This example shows how to enable the link trap monitoring on all ports.
C3(rw)->set linkflap portstate enable
set linkflap interval
Use this command to set the time interval (in seconds) for accumulating link down transitions.
Syntax
set linkflap interval port-string interval-value
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the link flap interval on port ge.1.4 to 1000 seconds.
C3(rw)->set linkflap interval ge.1.4 1000
set linkflap action
Use this command to set reactions to a link flap violation.
Syntax
set linkflap action port-string {disableInterface | gensyslogentry | gentrap |
all}
disable | enable Disables or enables the link flap detection function.
port-string (Optional) Specifies the port or ports on which to disable or enable
monitoring.
port-string Specifies the port(s) on which to set the link flap interval.
interval-value Specifies an interval in seconds. A value of 0 will set the interval to
forever.