Enterasys C3G124-24 - Commands

Configuring Link Layer Discovery Protocol and LLDP-MED
10-14 Discovery Protocol Configuration
Commands
The commands used to review and configure the CDP discovery protocol are listed below.
Step Task Command(s)
1. Configure global system LLDP parameters set lldp tx-interval
set lldp hold-multiplier
set lldp trap-interval
set lldp med-fast-repeat
clear lldp
2. Enable/disable specific ports to:
• Transmit and process received LLDPDUs
• Send LLDP traps
• Send LLDP-MED traps
set/clear lldp port status
set/clear lldp port trap
set/clear lldp port med-trap
3. Configure an ECS ELIN value for specific ports set/clear lldp port location-info
4. Configure Network Policy TLVs for specific ports set/clear lldp port network-policy
5. Configure which optional TLVs should be sent by
specific ports. For example, if you configured an
ECS ELIN and/or Network Policy TLVs, you must
enable those optional TLVs to be transmitted on
the specific ports.
set/clear lldp tx-tlv
For information about... Refer to page...
show lldp 10-15
show lldp port status 10-15
show lldp port trap 10-16
show lldp port tx-tlv 10-17
show lldp port location-info 10-17
show lldp port local-info 10-18
show lldp port remote-info 10-21
show lldp port network-policy 10-22
set lldp tx-interval 10-23
set lldp hold-multiplier 10-24
set lldp trap-interval 10-24
set lldp med-fast-repeat 10-25
set lldp port status 10-25
set lldp port trap 10-26
set lldp port med-trap 10-26
set lldp port location-info 10-27
set lldp port tx-tlv 10-28
set lldp port network-policy 10-29