Enterasys C3G124-24 - Set Port Enable; Show Port Alias

set port enable
11-8 Port Configuration
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to disable ge.1.1:
C3(su)->set port disable ge.1.1
set port enable
Use this command to administratively enable one or more ports.
Syntax
set port enable port-string
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to enable ge.1.3:
C3(su)->set port enable ge.1.3
show port alias
Use this command to display the alias name for one or more ports.
Syntax
show port alias [port-string]
port-string Specifies the port(s) to disable. For a detailed description of possible port-
string values, refer to “Port String Syntax Used in the CLI” on page 11-1.
port-string Specifies the port(s) to enable. For a detailed description of possible port-
string values, refer to “Port String Syntax Used in the CLI” on page 11-1.