Enterasys C3G124-24 - Set Port Speed; Show Port Duplex

set port speed
Enterasys C3 Configuration Guide 11-11
set port speed
Use this command to set the default speed of one or more ports. This setting only takes effect on
ports that have auto-negotiation disabled.
Syntax
set port speed port-string {10 | 100 | 1000}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set ge.3.3 to a port speed of 10 Mbps:
C3(su)->set port speed ge.3.3 10
show port duplex
Use this command to display the default duplex setting (half or full) for one or more ports.
Syntax
show port duplex [port-string]
Parameters
Defaults
If port-string is not specified, default duplex settings for all ports will be displayed.
Mode
Switch command, read-only.
port-string Specifies the port(s) for which to a speed value will be set. For a
detailed description of possible port-string values, refer to “Port
String Syntax Used in the CLI” on page 11-1.
10 | 100 | 1000 Specifies the port speed. Valid values are: 10 Mbps, 100 Mbps, or
1000 Mbps.
port-string (Optional) Displays default duplex setting(s) for specific port(s).
For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.