show port mirroring
Enterasys C3 Configuration Guide 11-39
2. Enter MIB option 5 (createAndWait) and perform an SNMP Set operation.
3. (Optional) Use the CLI to verify the port mirroring instance has been created set to disabled
mode as shown in the following example:
C3(su)->show port mirroring
Port Mirroring
==============
Source Port = ge.1.3
Target Port = ge.1.2
Frames Mirrored = Rx and Tx
Port Mirroring status disabled
4. When you are ready to enable this instance, enter MIB option 1 (active) and perform an SNMP
Set operation.
5. (Optional) Use the CLI to verify the port mirroring instance has been enabled.
To delete a port mirroring instance:
1. Select a previously created port mirroring instance in your MIB browser.
2. Enter MIB option 6 (destroy) and perform an SNMP Set operation.
3. (Optional) Use the CLI to verify the port mirroring instance has been deleted as shown in the
following example:
C3(su)->show port mirroring
No Port Mirrors configured.
Purpose
To review and configure port mirroring on the device.
Commands
show port mirroring
Use this command to display the source and target ports for mirroring, and whether mirroring is
currently enabled or disabled for those ports.
Syntax
show port mirroring
Parameters
None.
For information about... Refer to page...
show port mirroring 11-39
set port mirroring 11-40
clear port mirroring 11-41
set mirror vlan 11-41
clear mirror vlan 11-42
To Next Page
Loading...
Need help?
General