Enterasys C3G124-24 - Clear Dhcp Pool Netbios-Name-Server; Set Dhcp Pool Netbios-Name-Server

set dhcp pool netbios-name-server
22-26 DHCP Server Configuration
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example removes the domain name from the address pool “auto1.”
C3(rw)->clear dhcp pool auto1 domain-name
set dhcp pool netbios-name-server
Use this command to assign one or more NetBIOS name servers for the DHCP clients served by
the address pool being configured. Up to 8 NetBIOS name servers can be configured.
Syntax
set dhcp pool poolname netbios-name-server address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example assigns a NetBIOS name server at 10.15.10.1 to the address pool being configured.
C3(rw)->set dhcp pool auto1 netbios-name-server 10.15.10.1
clear dhcp pool netbios-name-server
Use this command to remove the NetBIOS namer server list from the address pool being
configured.
clear dhcp pool poolname netbios-name-server
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
address Specifies the IP address of a NetBIOS name server.
address2 ... address8 (Optional) Specifies, in order of preference, up to 7 additional NetBIOS
name server addresses.