clear system utilization
Enterasys C3 Configuration Guide 3-11
C3(rw)->set system utilization threshold 750
clear system utilization
Use this command to reset the CPU utilization threshold to the default of 80%.
Syntax
clear system utilization
Parameters
None.
Defaults
The default threshold value is 80%.
Mode
Switch command, read-write.
Example
This example resets the CPU utilization threshold to the default.
C3(rw)->show system utilization cpu
CPU Utilization Threshold Traps enable: Threshold = 75.0%
Total CPU Utilization:
Switch CPU 5 sec 1 min 5 min
-------------------------------------------------
1 1 10% 10% 10%
C3(rw)->clear system utilization
C3(rw)->show system utilization cpu
CPU Utilization Threshold Traps enable: Threshold = 80.0%
Total CPU Utilization:
Switch CPU 5 sec 1 min 5 min
-------------------------------------------------
1 1 14% 11% 10%
show system enhancedbuffermode
Use this command to display the status of enhanced buffer mode, which optimizes buffer
distribution into a single CoS queue operation for standalone switches or non-stacked switches.
Syntax
show system enhancedbuffermode
Parameters
None.
To Next Page
Loading...
