show macauthentication session
Enterasys C3 Configuration Guide 32-31
show macauthentication session
Use this command to display the active MAC authenticated sessions.
Syntax
show macauthentication session
Parameters
None.
Defaults
If port-string is not specified, MAC session information will be displayed for all MAC
authentication ports.
Mode
Switch command, read-only.
Usage
Changing the Reauth Period with the set macauthentication reauthperiod command does not
affect current sessions. New sessions display the correct period.
Example
This example shows how to display MAC session information:
C3(su)->show macauthentication session
Port MAC Address Duration Reauth Period Reauthentications
----- ----------------- ---------- ------------- -----------------
ge.1.2 00:60:97:b5:4c:07 0,00:52:31 3600 disabled
Table 32-4 provides an explanation of the command output.
Reauth Period Reauthentication period for this port. Default value of 30 can be changed using the
set macauthentication reauthperiod command (page 32-37).
Auth Allowed Number of concurrent authentications supported on this port.
Auth Allocated Maximum number of MAC authentications permitted on this port.
Reauthentications Whether or not reauthentication is enabled or disabled on this port. Set using the set
macauthentication reauthentication command (page 32-36).
Table 32-3 show macauthentication Output Details (Continued)
Output Field What It Displays...
Table 32-4 show macauthentication session Output Details
Output Field What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.
MAC Address MAC address associated with the session.
Duration Time this session has been active.
To Next Page
Loading...
Need help?
General