Enterasys C3G124-24 - Clear Switch Member; Set Switch Member

set switch member
Enterasys C3 Configuration Guide 2-11
set switch member
Use this command to add a virtual member to a stack. This allows you to preconfigure a switch
before the physical device is actually added to the stack.
Syntax
set switch member unit switch-id
Parameters
Defaults
None.
Mode
Switch command, read-write.
Usage
Refer to “Creating a Virtual Switch Configuration” on page 2-3 for more information about how to
add a virtual switch to a stack.
Example
This example shows how to specify a switch as unit 1 with a switch ID of 1:
C3(su)->set switch member 1 1
clear switch member
Use this command to remove a member entry from the stack.
Syntax
clear switch member unit
Parameters
Defaults
None.
Mode
Switch command, read-write.
unit Specifies a unit number for the switch.
switch-id Specifies a switch ID (SID) for the switch. SIDs can be displayed with the
show switch switchtype command.
unit Specifies the unit number of the switch.