exit
3-46 Basic Configuration
exit
Use this command to leave a CLI session.
Syntax
exit
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Usage
By default, switch timeout occurs after 15 minutes of user inactivity, automatically closing your
CLI session. Use the set logout command (page 3-25) to change this default.
Example
This example shows how to exit a CLI session:
C3(su)->exit
Resetting the Switch
Purpose
To reset one or more switches, and to clear the user-defined configuration parameters.
Commands
For information about... Refer to page...
reset 3-47
reset at 3-47
reset in 3-48
show reset 3-49
clear config 3-49
To Next Page
Loading...
