ip igmp version
17-12 IGMP Configuration
ip igmp version
Use this command to set the version of IGMP running on the router. The no form of this command
resets IGMP to the default version of 2 (IGMPv2).
Syntax
ip igmp version version
no ip igmp
Parameters
Defaults
None.
Mode
Interface configuration: C3(su)->router(Config-if(Vlan 1))#
Example
This example shows how to set the IGMP version to version 1 on VLAN 1:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip igmp version 1
show ip igmp interface
Use this command to display information about one or more IGMP routing interfaces.
Syntax
show ip igmp interface [vlan vlan-id]
Parameters
Defaults
If not specified, information will be displayed for all VLANs configured for IGMP routing.
Mode
Any router mode.
Example
This example shows how to display IGMP routing information for VLAN 1:
C3(su)->router#show ip igmp interface vlan 1
Vlan 1 is Admin UP
Vlan 1 is Oper UP
IGMP is configured via the Switch
IGMP ACL currently not supported
version Specifies the IGMP version number to run on the router. Valid values are
1, 2, or 3.
vlan vlan-id (Optional) Displays information for one or more VLANs.
To Next Page
Loading...
Need help?
General