Enterasys C3G124-24 - Configuring Classification Rules

Configuring Classification Rules
15-6 Policy Classification Configuration
Configuring Classification Rules
Purpose
To review, create, assign, and unassign classification rules to policy profiles. This maps user
profiles to protocol-based frame filtering policies.
Commands
show policy rule
Use this command to display policy classification rule information.
Syntax
show policy rule [all | admin-profile | profile-index] [ether | ipproto |
ipdestsocket | ipsourcesocket | iptos | macdest | macsource | tcpdestport |
tcpsourceport | udpdestport | udpsourceport] [data] [mask mask] [port-string port-
string] [rule-status {active | not-in-service | not-ready}] [storage-type {non-
volatile | volatile}] [vlan vlan] | [drop | forward] [dynamic-pid dynamic-pid]
[cos cos] [admin-pid admin-pid] [-verbose] [usage-list] [display-if-used]
Parameters
Note: A4, B3, B5, C3, C5, and G3 devices support profile-based CoS traffic rate limiting but do not
support rule-based rate limiting.
For information about... Refer to page...
show policy rule 15-6
show policy capability 15-8
set policy rule 15-10
clear policy rule 15-13
clear policy all-rules 15-14
all | admin-
profile | profile-
index
Displays policy classification rules for all profiles, the admin-profile, or for
a specific profile index number. Valid values are 1 - 1023.
ether Displays Ethernet type II rules.
ipproto Displays IP protocol field in IP packet rules.
ipdestsocket Displays IP destination address rules.
ipsourcesocket Displays IP source address rules.
iptos Displays Type of Service rules.
macdest Displays MAC destination address rules.
macsource Displays MAC source address rules.
tcpdestport Displays TCP destination port rules.