Alarm Group Commands
Enterasys C3 Configuration Guide 21-9
Alarm Group Commands
Purpose
To display, configure, and clear RMON alarm entries and properties.
Commands
show rmon alarm
Use this command to display RMON alarm entries. The RMON alarm group periodically takes
statistical samples from RMON variables and compares them with previously configured
thresholds. If the monitored variable crosses a threshold an RMON event is generated.
Syntax
show rmon alarm [index]
Parameters
Defaults
If index is not specified, information about all RMON alarm entries will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display RMON alarm entry 3:
C3(rw)->show rmon alarm 3
Index 3
---------------------
Owner = Manager
Status = valid
Variable = 1.3.6.1.4.1.5624.1.2.29.1.2.1.0
Sample Type = delta Startup Alarm = rising
Interval = 30 Value = 0
Rising Threshold = 1 Falling Threshold = 0
Rising Event Index = 2 Falling Event Index = 0
Table 21-2 provides an explanation of the command output.
For information about... Refer to page...
show rmon alarm 21-9
set rmon alarm properties 21-10
set rmon alarm status 21-11
clear rmon alarm 21-12
index (Optional) Displays RMON alarm entries for a specific entry index ID.
To Next Page
Loading...
Need help?
General