Enterasys C3G124-24 User Manual

set dhcp
22-4 DHCP Server Configuration
set dhcp
Use this command to enable or disable the DHCP server functionality on the Enterasys C3.
Syntax
set dhcp {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example enables DHCP server functionality.
C3(rw)->set dhcp enable
set dhcp bootp
Use this command to enable or disable automatic address allocation for BOOTP clients. By
default, address allocation for BOOTP clients is disabled. Refer to RFC 1534, “Interoperation
Between DHCP and BOOTP,” for more information.
Syntax
set dhcp bootp {enable | disable}
Parameters
set dhcp exclude 22-7
clear dhcp exclude 22-7
set dhcp ping 22-8
clear dhcp ping 22-8
show dhcp binding 22-9
clear dhcp binding 22-9
show dhcp server statistics 22-10
clear dhcp server statistics 22-11
For information about... Refer to page...
enable | disable Enables or disables DHCP server functionality. By default, DHCP server is
disabled.
enable | disable Enables or disables address allocation for BOOTP clients.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English