Configuring SNTP show sntp interface
20-10
Example
The following example sets the timezone name to EST and the offset to North American Eastern
Standard Time offset of -5 hours from UTC, then displays the timezone used with SNTP.
C3(su)->set timezone EST -5
C3(su)->show sntp
SNTP Version: 3
Current Time: FRI MAY 13 06:11:19 2011
Timezone: 'EST' offset from UTC is -5 hours and 0 minutes
Client Mode: unicast
Trusted Keys : 1 2
Broadcast Count: 1
Poll Interval: 6 (64 seconds)
Poll Retry: 4
Poll Timeout: 10 seconds
SNTP Poll Requests: 0
Last SNTP Update: THU JAN 01 00:00:00 1970
Last SNTP Request: THU JAN 01 00:00:00 1970
Last SNTP Status: Other
SNTP-Server Precedence Key Status
----------------------------------------------------
2001::20:1:180:45 1 1 Active
10.2.8.6 2 2 Active
show sntp interface
Use this command to display the interface used for the source IP address of the SNTP client.
Syntax
show sntp interface
Parameters
None.
Defaults
None.
Mode
Switch mode, read-only.
Example
This example displays the output of this command. In this case, the IP address assigned to
loopback interface 1 will be used as the source IP address of the SNTP client.
C3(rw)->show sntp interface
loopback 1 192.168.10.1
To Next Page
Loading...
Need help?
General