Commands
Enterasys C3 Configuration Guide 5-5
Commands
show system login
Use this command to display local login account information.
Syntax
show system login
Parameters
None.
Defaults
None.
Mode
Switch command, super user.
Example
This example shows how to display login account information. In this case, switch defaults have
not been changed:
C3(su)->show system login
Username Access State Aging Simul Local Login Access Allowed
Login Only? Start End Days
admin super-user enabled 0 0 no ***access always allowed***
ro read-only enabled 0 0 no ***access always allowed***
rw read-write enabled 0 0 no ***access always allowed***
guest read-only enabled 0 0 no 00:00 24:00 mon tue wed thu fri
Table 5-1 provides an explanation of the command output.
For information about... Refer to page...
show system login 5-5
set system login 5-6
clear system login 5-8
set password 5-9
set system password-resetbutton 5-10
show system password 5-10
set system password 5-13
clear system password 5-15
show system lockout 5-17
set system lockout 5-18
To Next Page
Loading...
