Enterasys C3G124-24 - Clear Spantree Portpri

clear spantree portpri
13-40 Spanning Tree Configuration
Parameters
Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Mode
Switch command, read-write.
Example
This example shows how to set the priority of ge.1.3 to 240 on SID 1
C3(su)->set spantree portpri ge.1.3 240 sid 1
clear spantree portpri
Use this command to reset the bridge priority of a Spanning Tree port to a default value of 128.
Syntax
clear spantree portpri port-string [sid sid]
Parameters
Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Mode
Switch command, read-write.
Example
This example shows how to reset the priority of ge.1.3 to 128 on SID 1
C3(su)->clear spantree portpri ge.1.3 sid 1
port-string Specifies the port(s) for which to set Spanning Tree port priority. For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.
priority Specifies a number that represents the priority of a link in a Spanning Tree
bridge. Valid values are from 0 to 240 (in increments of 16) with 0
indicating high priority.
sid sid (Optional) Sets port priority for a specific Spanning Tree identifier. Valid
values are 0 - 4094. If not specified, SID 0 is assumed.
port-string Specifies the port(s) for which to set Spanning Tree port priority. For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.
sid sid (Optional) Resets the port priority for a specific Spanning Tree identifier.
Valid values are 0 - 4094. If not specified, SID 0 will be assumed.