show access-lists Configuring Access Control Lists
Enterasys C3 Configuration Guide 34-3
Enabling or disabling IPv6 mode requires a reset of the switch.
Examples
This example enables IPv6 mode.
C3(su)->router(Config)#access-list ipv6mode
Changing ipv6mode will result in a system reset.
Do you wish to proceed? (y/n) y
This example disables IPv6 mode after it has been enabled.
C3(su)->router(Config)#no access-list ipv6mode
Changing ipv6mode will result in a system reset.
Do you wish to proceed? (y/n) y
show access-lists
Use this command to display configured IP access lists when operating in router mode.
Syntax
show access-lists [name] | [number] | [ipv6mode] | [interface [port-string]] |
[vlan [vlan-id]]
Parameters
Defaults
If no optional parameter is specified, the entire table of access lists will be displayed.
If a port-string is not specified, all ports with associated access control lists will be displayed.
If a vlan-id is not specified, all VLANs with associated access control lists will be displayed.
Mode
Any router mode.
Examples
This example shows how to display IP access list number 145. This is an extended access list,
which permits or denies ICMP, UDP and IP frames based on restrictions configured with one of
the access-list commands. For details on configuring standard access lists, refer to “access-list
(standard)” on page 34-4. For details on configuring extended access lists, refer to “access-list
(extended)” on page 34-6
.
C3(su)->router#show access-lists 145
name (Optional) Displays information for the access control list specified by name.
number (Optional) Displays information for the access control list specified by
number. Valid values are between 1 and 199.
ipv6mode (Optional) Displays the status of IPv6 mode, either enabled or disabled.
interface port-
string
(Optional) Displays the access control lists associated with the specified port
or ports, or all ports.
vlan vlan-id (Optional) Displays the access control list associated with the specified
VLAN, or all VLANs
To Next Page
Loading...
