show logging local Configuring System Logging
Enterasys C3 Configuration Guide 19-11
Example
This example shows how to reset the logging severity level to 6 for SNMP.
C3(rw)->clear logging application SNMP
show logging local
Use this command to display the state of message logging to the console, the Syslog persistent file,
and to the security audit log.
Syntax
show logging local
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the state of message logging. In this case, logging to the
console is enabled and logging to the Syslog persistent file and security audit log file is disabled.
C3(su)->show logging local
Syslog Console Logging enabled
Syslog File Logging disabled
Syslog Security Audit Logging disabled
set logging local
Use this command to configure log messages to the console and a persistent file. Optionally, you
can also enable or disable the security audit log if you have super-user access.
Syntax
set logging local console { enable | disable} file { enable | disable} [sfile { enable
| disable}]
Parameters
console enable | disable Enables or disables logging to the console. Enabled is the default
condition.
file enable | disable Enables or disables logging to a Syslog persistent file. Disabled is
the default condition.
sfile enable | disable (Optional) Enables or disables logging to the security audit log
file. Disabled is the default condition.
This parameter is available only if you have super-user access.
To Next Page
Loading...
Need help?
General