show multiauth
32-42 Authentication and Authorization Configuration
show multiauth
Use this command to display multiple authentication system configuration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display multiple authentication system configuration:
C3(rw)->show multiauth
Multiple authentication system configuration
-------------------------------------------------
Supported types : dot1x, pwa, mac
Maximum number of users : 768
Current number of users : 2
System mode : multi
Default precedence : dot1x, pwa, mac
Admin precedence : dot1x, pwa, mac
Operational precedence : dot1x, pwa, mac
show multiauth station 32-47
show multiauth session 32-47
show multiauth idle-timeout 32-48
set multiauth idle-timeout 32-49
clear multiauth idle-timeout 32-50
show multiauth session-timeout 32-50
set multiauth session-timeout 32-51
clear multiauth session-timeout 32-52
For information about... Refer to page...
To Next Page
Loading...
Need help?
General