ipv6 router ospf
31-4 OSPFv3 Configuration
Example
This example illustrates configuring the OSPFv3 router ID as 2.2.2.2.
C3(su)->router(Config)# ipv6 router id 2.2.2.2
ipv6 router ospf
This command enters Router OSPFv3 configuration mode.
Syntax
ipv6 router ospf
Parameters
None.
Defaults
None.
Mode
Router global configuration: C3(su)->router(Config)#
Usage
Use this command to enter OSPFv3 configuration mode so you can configure global OSPFv3
parameters.
Example
This example illustrates entering router OSPFv3 configuration mode.
C3(su)->router(Config)# ipv6 router ospf
C3(su)->router(Config-router)#
default-information originate
This command is used to control the advertisement of default routes.
Syntax
default-information originate [always] [metric value] [metric-type type]
no default-information originate [metric] [metric-type]
Parameters
always (Optional) Always advertises the default route information.
metric value (Optional) Specifies the metric of the default route. The metric value can
range from 0 to 16777214.
metric-type type (Optional) Specifies the metric type of the default route. The metric type
can be 1, which specifies type 1 external route, or 2, which specifies type
2 external route.
To Next Page
Loading...
Need help?
General