Enterasys C3G124-24 - Show Ip Mroute; Show Ip Pimsm Staticrp Output Details

show ip mroute
Enterasys C3 Configuration Guide 27-47
show ip mroute
Use this command to display the IP multicast routing table.
Syntax
show ip mroute
Parameters
None.
Defaults
None.
Mode
Any router mode.
Usage
The multicast routing table shows how a multicast routing protocol, such as PIM and DVMRP,
will forward a multicast packet. Information in the table includes source network/mask and
upstream neighbors.
For information about DVMRP, see “Configuring DVMRP” on page 27-25.
Example
This example shows the output of this command.
C3(su)->router#show ip mroute
Active IP Multicast Sources
Flags: D - Dense, S - Sparse, C - Connected, L - Local,P - Pruned, R - RP-bit set,
F - Register flag, T - SPT-bit set,Outgoing interface flags: H - Hardware switched
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
Source Network : 192.168.111.10
Source Mask : 0.0.0.0
MultiCast Group : 239.1.8.9
Uptime : 6336
Upstream Neighbor: 0.0.0.0
Upstream Vlan : 111
Downstream Vlans : 8
Source Network : 192.168.111.10
Source Mask : 0.0.0.0
MultiCast Group : 239.1.7.105
Uptime : 6336
Table 27-13 show ip pimsm staticrp Output Details
Output Field What it displays
Address The IP address of the RP.
Group Address The group address supported by the RP.
Group Mask The group mask for the group address.