clear nodealias config
Enterasys C3 Configuration Guide 18-19
Usage
Upon packet reception, node aliases are dynamically assigned to ports enabled with an alias
agent, which is the default setting on Enterasys C3 devices. Node aliases cannot be statically
created, but can be deleted using the command “clear nodealias config” (page 18-19).
It's important to make sure that inter-switch links are not learning node/alias information, as it
would slow down searches by the NetSight Compass and ASM tools and give inaccurate results.
Example
This example shows how to disable the node alias agent on ge.1.3:
C3(su)->set nodealias disable ge.1.3
clear nodealias config
Use this command to reset node alias state to enabled and clear the maximum entries value.
Syntax
clear nodealias config port-string
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to reset the node alias configuration on ge.1.3:
C3(su)->clear nodealias config ge.1.3
port-string Specifies the port(s) on which to reset the node alias configuration.
To Next Page
Loading...
