Enterasys C3G124-24 - Clear Sflow Port Sampler; Set Sflow Interface

clear sflow port sampler
37-14 sFlow Configuration
ge.1.2 1 1024 128
ge.1.3 1 1024 128
ge.1.4 1 1024 128
ge.1.5 1 1024 128
ge.1.6 1 1024 128
ge.1.7 1 1024 128
ge.1.8 1 1024 128
clear sflow port sampler
Use this command to change the sampler rate or maximum header size, or to remove sampler
instances.
Syntax
clear sflow port port-string sampler [maxheadersize | rate]
Parameters
Defaults
If neither optional parameter is specified, the sampler instance is cleared.
Mode
Switch command, read-write.
Example
This example removes the sampler instance on port ge.1.1.
C3(su)->clear sflow port ge.1.1 sampler
set sflow interface
Use this command to specify the interface used for the source IP address of the sFlow Agent when
sending sampling datagrams to the sFlow Collector.
Syntax
set sflow interface {loopback loop-ID | vlan vlan-ID}
Parameters
port-string Specifies the port or ports on which the sampler instance is being
cleared.
maxheadersize (Optional) Specifies that the maximum header size should be cleared to
the default value of 128 bytes.
rate (Optional) Specifies that the sampling rate should be cleared to the
default value of 0, which disables sampling by the instance.
loopback loop-ID Specifies the loopback interface to be used. The value of loop-ID can
range from 0 to 7.