set igmpsnooping mcrtrexpiretime
17-6 IGMP Configuration
Example
This example shows how to set the IGMP maximum response time to 100 seconds:
C3(su)->set igmpsnooping maxresponse 100
set igmpsnooping mcrtrexpiretime
Use this command to configure the IGMP multicast router expiration time for the system.
Syntax
set igmpsnooping mcrtrexpire time
Parameters
Defaults
None.
Mode
Switch command, read-write.
Usage
This timer is for expiring the switch from the multicast database. If the timer expires, and the only
address left is the multicast switch, then the entry will be removed.
Example
This example shows how to set the IGMP multicast router expiration time to infinity:
C3(su)->set igmpsnooping mcrtrexpiretime 0
set igmpsnooping add-static
This command creates a new static IGMP entry or adds one or more new ports to an existing entry.
Syntax
set igmpsnooping add-static group vlan-list [modify] [port-string]
Parameters
Defaults
If no ports are specified, all ports are added to the entry.
time Specifies the IGMP multicast router expiration time. Valid values are 0 -
3600 seconds. A value of 0 will configure the system with an infinite
expiration time. The default value is 0.
group Specifies the multicast group IP address for the entry.
vlan-list Specifies the VLANs on which to configure the entry.
modify (Optional) Adds the specified port or ports to an existing entry.
port-string (Optional) Specifies the port or ports to add to the entry.
To Next Page
Loading...
Need help?
General