Enterasys C3G124-24 - Show Lldp Port Location-Info; Show Lldp Port Tx-Tlv

show lldp port tx-tlv
Enterasys C3 Configuration Guide 10-17
show lldp port tx-tlv
Use this command to display information about which optional TLVs have been configured to be
transmitted on ports. Ports are configured to send optional TLVs with the set lldp port tx-tlv
command.
Syntax
show lldp port tx-tlv [port-string]
Parameters
Defaults
If port-string is not specified, TLV configuration information will be displayed for all ports.
Mode
Switch command, read-only.
Example
This example shows how to display transmit TLV information for three ports.
C3(ro)->show lldp port tx-tlv ge.1.1-3
* Means TLV is supported and enabled on this port
o Means TLV is supported on this port
Means TLV is not supported on this port
Column Pro Id uses letter notation for enable: s-stp, l-lacp, g-gvrp
Ports Port Sys Sys Sys Mgmt Vlan Pro MAC PoE Link Max MED MED MED MED
Desc Name Desc Cap Addr Id Id PHY Aggr Frame Cap Pol Loc PoE
------- ---- ---- ---- --- ---- ---- ---- --- --- ---- ---- --- --- --- ---
ge.1.1 * * * * * * slg * * * * *
ge.1.2 * * * * * * slg * * *
ge.1.3 * * * * * * slg * * * * *
show lldp port location-info
Use this command to display configured location information for one or more ports. Ports are
configured with a location value using the set lldp port location-info command.
Syntax
show lldp port location-info [port-string]
Parameters
port-string (Optional) Displays information about TLV configuration for one or a
range of ports.
port-string (Optional) Displays port location information for one or a range of
ports.