show lacp
Enterasys C3 Configuration Guide 11-47
Multi-port LAGs will continue to operate as long as there is at least one active port in the LAG.
Therefore, there is no need to create backup single port LAGs or to specifically assign the LAG and
all its physical ports to the egress list of the LAG’s VLAN.
Typically, two or more ports are required to form a LAG. However, you can enable the creation of
single port LAGs as described in “set lacp singleportlag” on page 11-52. If a single port LAG goes
down and the switch stays up, the switch will reconfigure the LAG to the same LAG number if the
port comes back up.
Commands
show lacp
Use this command to display information about one or more aggregator ports.
Syntax
show lacp [port-string]
Parameters
Note: To aggregate, underlying physical ports must be running in full duplex mode and must be of
the same operating speed.
For information about... Refer to page...
show lacp 11-47
set lacp 11-49
set lacp asyspri 11-49
set lacp aadminkey 11-50
clear lacp 11-50
set lacp static 11-51
clear lacp static 11-52
set lacp singleportlag 11-52
clear lacp singleportlag 11-52
show port lacp 11-53
set port lacp 11-55
clear port lacp 11-57
set lacp groups 11-58
clear lacp groups 11-59
show lacp groups 11-59
port-string (Optional) Displays LACP information for specific LAG port(s).
Valid port designations are lag.0.1 – 24 depending on the number of LAG
groups configured.
To Next Page
Loading...
