show users
18-4 Network Management
show users
Use this command to display information about the active console port or Telnet session(s) logged
in to the switch.
Syntax
show users
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to use the show users command. In this output, there are two Telnet
users logged in with Read-Write access privileges from IP addresses 134.141.192.119 and
134.141.192.18:
C3(su)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
disconnect
Use this command to close an active console port or Telnet session from the switch CLI.
Syntax
disconnect {ip-addr | console}
Parameters
Defaults
None.
Mode
Switch command, read-write.
ip-addr Specifies the IP address of the Telnet session to be disconnected. This
address is displayed in the output shown in “show users” on page 12-15.
console Closes an active console port.
To Next Page
Loading...
