Configuring System Logging clear logging application
19-10
Defaults
If level is not specified, none will be applied.
If no servers are specified, messages will be sent to all configured Syslog servers.
Mode
Switch command, read-write, if security profile = normal.
Switch command, super-user, if security profile = c2
Example
This example shows how to set the severity level for SNMP to 4 so that error conditions will be
logged for that application and sent to Syslog server 1.
C3(rw)->set logging application SNMP level 4 server 1
clear logging application
Use this command to reset the logging severity level for one or all applications to the default value
of 6 (notifications of significant conditions).
Syntax
clear logging application {mnemonic | all}
Parameters
Defaults
None.
Mode
Switch command, read-write, if security profile = normal.
Switch command, super-user, if security profile = c2
Security Security audit logging
RtrOspf OSPF
RtrMcast Multicast
RtrVrrp VRRP
Table 19-3 Mnemonic Values for Logging Applications (Continued)
Mnemonic Application
mnemonic Resets the severity level for a specific application to 6. Valid mnemonic
values and their corresponding applications are listed in Table 19-3 on
page 19-9.
all Resets the severity level for all applications to 6.
To Next Page
Loading...
