Enterasys C3G124-24 User Manual

ip pimsm enable
Enterasys C3 Configuration Guide 27-39
Parameters
Defaults
None.
Mode
Global Router configuration: C3(su)->router(Config)#
Example
This example shows how to set an RP for a specific multicast group.
C3(su)->router(Config)# ip pimsm staticrp 192.15.18.3 224.0.0.0 240.0.0.0
ip pimsm enable
This command sets the administrative mode of PIM-SM multicast routing on a routing interface to
enabled. By default, PIM is disabled on all IP interfaces. The no form of this command disables
PIM on the specific interface.
Syntax
ip pimsm enable
no ip pimsm enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C3(su)->router(Config-if(Vlan 1))#
Example
This example shows how to enable PIM on IP interface for VLAN 1.
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip pimsm enable
ipaddress The IP address of the Rendezvous Point
groupadress The group address supported by the Rendezvous Point
groupmask The group mask for the group address

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English